This job included a full amp service upgrade for Bellport Plaza. One of the ten stores in this shopping center is Family Dollar where we also worked on a full renovation.
Our technicians replaced the shopping center’s previous system from 3 overhead services totaling 500 amps to a 2000 amp service. Each store has nowbeen designated a 200 amp service, allowing each store more than enough power for any need possible.
The previous overhead service was not adequate enough to run each store and PSEG required new underground service, rendering all the existing services obsolete. To install an underground amp service we had to call for a markout where an excavation company is called in and proceeds to dig for the transformer pad and the primary cable, which will run to the nearest pole. The multi-ton concrete transformer pad is then dropped into the hole, 52 inches deep and leveled. All connections are made inside the vault underground, housing 13,200 volts.
During the markout we came across some obstacles where our technicians had to excavate some utilities by hand, specifically dealing with the cesspool, drainage, water system, buried phone cables and gas. There was also a tree that we had to trim which allowed the excavator to be able to drop the concrete pad into the ground.
In addition, the town also required a certificate of occupancy on all stores upon completion of the family dollar renovation. Our technicians made all the electrical service repairs to each store, replacing the outdated system and bringing everything back up to code.
At Absolute Electrical Service, No Job Is Too Small and Emergency Service is available. Contact us today for a free electrical estimate.
A service panel upgrade replaces the main breaker box and incoming service equipment so your home can safely carry the electrical load it actually uses today. Older Long Island houses were frequently wired for 60 or 100 amps, which was plenty when a kitchen held a toaster and a fridge. Add central air, an induction range, a hot tub, a heat pump, or an EV charger and that capacity runs out fast. Warning signs are hard to ignore: breakers that trip under normal use, lights that dim when the AC kicks on, a warm or buzzing panel, scorched breaker faces, or a legacy brand like Federal Pacific or Zinsco that insurers now flag.
Done correctly, an upgrade is more than swapping a box. It means pulling the right PSEG Long Island permit, coordinating the meter and service drop, sizing the main breaker and conductors to code, and installing an up-to-date panel with proper grounding, bonding, and clearly labeled circuits. Many towns require an electrical inspection before power is reconnected, so the work has to pass the first time. A 200-amp service is the common target for a modern single-family home, giving you headroom for future additions instead of another round of tripping breakers two years from now.
A panel upgrade usually touches other parts of a home's electrical system, from grounding and surge protection to new circuits for generators, EV chargers, or HVAC. Explore related residential services below, and see the Nassau and Suffolk communities where we handle service upgrades, meter coordination, and inspection sign-offs across Long Island.
[wpbr_collection id="76"]
Phone: 718-229-9300
Address: 224-08 Linden Blvd., Cambria Heights, NY 11411
Phone: 516-520-4700
Address: 2938 Hempstead Turnpike, Levittown, NY 11756
Phone: 631-567-1500
Address: 1115 Smithtown Avenue, Bohemia, NY 11716